GV250, GV125, Aquila

Hyosung GV250 GT250R GT250 GT650 GV650 GT650R MS3-250 GD250R TE450S Key Stock Way Magneto Flywheel

Hyosung OEM Key Stock. #7 in picture.

GV250 Right Side Handle Switch Kill Start Carb Models (early Version)

Hyosung OEM part for 2003 and 2004, may also fit 2001 and 2002 GV250. May also fit the GV125. #1 in picture. Very low quantity available. Fits the 1" Handle bars. Special Order Item and very limited quantity available.

GV250 GV650 ST7 Left Grip

Hyosung OEM original left grip comp. #7 in picture.

GV250 Right Throttle Grip Sleeve (1 inch older version)

Hyosung OEM original throttle grip tube. #2 in picture. This is for the 2004 and older versions with the 1 inch bars.

Flywheel Puller GV250 GT250R GT250 EFI MS3-250 GD250R

This is the smaller puller with the 1.5mm thread pitch. Fits the updated rotor on the 2013 and newer EFI 250 Hyosung models. May fit some of the 2010 -2013 or may require the larger puller we have listed. Instructions: Wrap threads of flywheel with...

Float Assembly Hyosung GV250 GT250 GT250R

Hyosung OEM Float for GV125, GV250, GT250, GT125 and GT250R. #74 in picture. Sold individually.

Screw, Hyosung Fuel Pump

Hyosung OEM original part. Sold individually. #19 in picture.

Exhaust Cam for GV250 GT250R and GT250 Front Rear

Hyosung OEM part for all years GV250, GT250R and GT250 front and rear cylinders. #17 in picture. Special Order Item.

Intake Cam for GV250 GT250R GT250

Hyosung OEM original part. Fits Front cylinder on all GV250, GT250R and GT250 as well as rear cylinder on GV250. #18 in picture. Special Order Item.

GV250 Rear Intake Boot Pipe with port

*** When out of stock we have the neck without the port. (13120HJ8201) You can T off from the other neck if needed *** Hyosung OEM rear intake neck for GV250. This is the updated neck with a vacuum port. #4 in picture.

GV250 Aquila Wiring Harness Loom 2009 2008 2007 2006 2005

Hyosung OEM wiring harness for carbureted GV250 with 3 plug CDI. Older units will also need to update CDI from the 2 plug version to the 3 plug version.

Starter Clutch GT250 GT250R GV250 older version

Fits earlier years GT250, GT250R and GV250 units. 12614HS5000 must be installed with 12620HJ8204 which is the starter clutch gear with holes. We currently do not have accurate information when Hyosung switched to this new system, but this was around...