Tools

Motion Pro 18mm Spark Plug Socket Thin wall

Originally designed for Honda XR400s as a trail tool, but fits many models with 18mm plugs Thinwall design to fit into low clearance plug cavity Socket can be driven with various tools including the Motion Pro spark plug ratchet wrench, 3/8 in. ratchet,...

Motion Pro Gear Set 08-0229 Rebuild Kit 90 Degree Tool

Gear set, replacement Durable nickel pewter finish

Motion Pro Adapt Kit for Air-Cooled Engine

Kit includes an extended thread adapter and dial indicator extension. Allows Water-Cooled 2-Stroke Timing Kit (08-0250) to be used on air cooled engines. Adapter kit does not allow two stroke timing kit 08-0250 to be installed on Yamaha RD two stroke...

Motion Pro Rotor and Sprocket Holder

Keeps flywheels, rotors and sprockets from rotating during removal and installation Holds sprockets and rotors with holes center to center at a minimum distance of 13mm and a maximum distance of 230mm Features 5 and 9mm pins Adjustable stop-screw keeps...

Motion Pro Folding Sag Scale

Can be used to check front or rear sag Folding design fits in most tool boxes Adjustable zero set point for direct scale reading (no subtracting required) Adjustable locating pin fits hollow axles Inch and metric scales Works on mini and full size...

Motion Pro Master Link Pliers Clip

Designed to simplify installation and removal of clip-type master links One tip is shorter and notched to be placed on the pin which allows the longer end to push the clip

Motion Pro Snap Ring Pliers

Economical pliers that easily work with both inside and outside opening snap rings or clips Includes 3 extra sets of tips, 1 additional straight tip and 2 offset angled tips

Pincers O Clip

Used to install O-clips PVC coated grip Clips in picture not included

Motion Pro Clutch Flywheel Magneto Holder Gear Sprocket

Made from medium carbon steel with hardened jaws Hold clutch hubs, flywheels, gears, sprockets, etc. Features 8mm spanner pins Jaws open up to 5 inches wide Recommended for square tooth style clutch hubs Not recommended for v-groove or half round style...

Motion Pro Jumbo Chain Tool Combo with Quad Stake Rivit Kit

Designed to break roller chain up to 630 (Fits all standard & O-ring chain sizes 520 to 630) Designed to rivet chain up to 530 (not 630) Masterlink side plate press kit included to press on side plates on chains up to 530 (not 630) Screws &...

49mm Dual Chamber Fork Cap Wrench Motion Pro

49 mm, 8 point box wrench for removing the fork cap (cartridge) on dual chamber closed cartridge forks on late-model Yamaha's & Honda's (2010 Honda CRF250R uses 08-0236 Fork cap wrench) 12 mm slot for holding the damper rod for removing the...

50mm WP Dual Chamber Fork Cap Wrench Motion Pro

50 mm, 6 point box wrench for removing the fork cap (cartridge) on WP 4860 MXMA dual chamber closed cartridge (WP USD 48 mm) forks on late-model KTM's 12 mm slot for holding the damper rod for removing the rebound bolt.  This allows for the removal...